My clutch slips... Anyone had this or got ideas to fix it?

[MT account]

and a modded 600 can on the rear? i got 1 of them under the bench which i could get mated to a header as the ground clearance looks good.

 

[graeme.doolan]

So after a little research it appears that the MT-09 shares the same clutch as 2009-2012 R1, YZ450F '03-'06 to name a few. So that means I could use the upgraded R1 clutch? Kevlar kitted one...

 

[graeme.doolan]

I will post up my findings once I purchase the Kevlar R1 unit

 

[MT account]

I will post up my findings once I purchase the Kevlar R1 unit

you seem to be the pathfinder in the performance mods mate so we will await your findings.....

 

[graeme.doolan]

you seem to be the pathfinder in the performance mods mate so we will await your findings.....

Hahaha yep my R&D consists of break it then develop it.

 

[graeme.doolan]

Yep they used the Yamalube and that's where things seem to go pear shaped

 

[MT account]

Yep they used the Yamalube and that's where things seem to go pear shaped

according to that temprature chart above i can use 20/50............jeeze! last time i used that was in my vw beetles........strangely enough the clutch didnt slip in them under FULL power............

 

[Kinjane]

You don't ride sub zero?

 

[MT account]

You don't ride sub zero?

i rode 2600m up a mountain last year in the middle of winter and it got down to 5 degrees...........30 mins later at the bottom we were back to 30 degrees in the shade.............

 

[Kinjane]

30 degrees in the shade.....Definately not Wales then Last time I came anywhere close to covering anything like that variation in altitude I became very ill.