Search results

I wound amalgamating tape round my chrome ball.

Very good!

There is a Garmin clap with a ball on that U bolts to handle bars. Looking on eBay, everything is so expensive, I think I would look for a kitchen cabinet door knob. 25 mm in Crome finish (£5 is). Drill a hole top to bottom then thro your bar, and bolt it on.

Well you can only measure the distance between each side of your clamp or try fit it. I think it will be too near and hide the clocks a little, as owle said you will need a ball mount on the back of your Garmin and the clamp that goes between the two balls, but fit it around your round bar...

B&Q. Chainsaw oil. With Tutoro oiler.

Just untighten the 4 bolts at the centre of the bars. Not too much then move the bars the way you want. Tighten the bolts again. Now pull the bars each way checking that the don't hit the tank. If you need more adjustment then you could fit handle bar risers, to allow more movement before...

I screwed a nice round headed numberplate screw half way in the top of it . It's easy now just get hold of screw head now.

Only 66. Young.

You could just try some spacers to hold the screen say a cms or 2 away from the clocks. This allows the wind to come up under the screen. It causes a vortex when it meets the wind on the front, pushing it higher up. It's a no cost option and may just be good.

Just stick a small but long screw driver under the grip, sword some WD40 in and circle the the bar with the screw driver, then swift again, till the grip just pulls off.

Looking at the wires on the right hand side, there are 2 connectors one for left and one for right. Yamaha grips fit straight to these! I don't see why you can't plug other grip in and use the computer to switch them on!

Hi Paolo Welcome. Did you get the MT09 or the MT07. Both great bikes!

I'll have both sets please. Message sent via email.

Mud flap Well I can't see how to make a new post, so if moderaters will do it and tell me how. I missing summat! Rear mud flap. I been having a little play and used a bit of wagon inner tube, fitted it on a flat bar. Bent each end in right angle and drilled 8mm holes to take a longer nut...

Of course if you bought a £1500 - £2000 Rukka suit you will find the outer cuff of the jacket folds up your arm so that the inner cuff will go inside your gloves. Then fold down the outer cuff to go over your glove. Best of both worlds.!

I always wear my jacket sleeves over my gloves. It allows the rain to run down my arm without it going into my gloves. The rain doesn't run up with the wind as you might think. Any kind of Gortex cloves should be water proof and fit under the end of your sleeves.

Some pics would help?

Patience dear.

That link doesn't work for me!

I bought a pair of these a few years ago! Have a look on eBay for twin car horns. Twin tone air Snail horn siren set car Truck van boat MEGA LOUD SNAIL Dual 12V | eBay